Tilausrivit 0

Ahlsell Tuotteet Teollisuus Paineilma Pneumatiikka Ilman esikäsittely Ilman esikäsittely FestoKondensiovedenpoisto Festo

Kondensiovedenpoisto Festo

Vedenerotin Festo MS6-LWS MS-sarjat

Vedenerotin Festo MS6-LWS MS-sarjat

Tuotenumero: T18005110

Flow rate 2,400 … 3,800 l/min. Temperature range +1 … +60 °C. Operating pressure 0.8 … 16 bar.
The maintenance-free water separator removes condensate from the compressed air. Constantly high condensate separation (99%) up to the maximum flow rate. Metal bowl. Available with fully automatic or fully automatic, electrically actuated condensate drain. Optional device variant EX4 for use in potentially explosive areas in zones 1, 2, 21 and 22.

Vedenerotin Festo MS6-LWS MS-sarjat

Vedenerotin Festo MS6-LWS MS-sarjat

Vedenerotin Festo MS9-LWS, MS-sarja

Vedenerotin Festo MS9-LWS, MS-sarja

Tuotenumero: T18005129

Water separators MS9-LWS, MS series. Fully automatic.

Kondensiokuivain Festo WA

Kondensiokuivain Festo WA

Tuotenumero: T18101775

Temperature range 0 … +60 °C. Operating pressure 1.5 … 16 bar
For attachment to service units and compressed air networks/systems. Condensate present in the compressed air is separated in suitable filters. The condensate that accumulates must be emptied from time to time, as otherwise it would be drawn in and could lead to faults in the downstream elements. The devices shown perform this task automatically. They contain a float which opens when a certain condensate level is achieved. The accumulated condensate is then emptied. With an additional, installed manual override, condensate emptying can also be performed manually. Automatic emptying after the max. fill level has been reached. Automatic emptying after the operating pressure p < 0.5 bar is switched off. Manual actuation during operation is possible

Kondensiokuivain Festo PWEA

Kondensiokuivain Festo PWEA

Tuotenumero: T18104505

Temperature range +1 … +60 °C. Operating pressure 0.8 … 16.0 bar.
Condensate passes through the port in the bottom of the filter bowl into the attached condensate drain valve, where it is collected in a reservoir. A capacitive sensor detects once the maximum filling level is reached. The condensate escapes into the atmosphere via the opening diaphragm valve through the discharge line. The diaphragm valve closes again after a specified response time. A residual amount of condensate remains in the reservoir so that no compressed air can escape into the discharge line. Fully automatic condensate drain with integrated electrical controller. Interface for communicating with master control device. Reliable thanks to non-contacting capacitive sensor. Can be used with service units or simply in piping systems. Operated via touch-sensitive keys or electrical interface. Ready status and switching status indicated via LEDs and electrical interface.

Kondensiokuivain Festo PWEA